Network & Drivers
In order to request a license - this will only happen for systems with version 55 and older (after 2022), you need to start your Geocomp software, then go t...
Wed, 27 Mar, 2024 at 4:25 PM
Network Card and Driver Installation Please find the attached document for short manual of network card and driver installation. Please download the...
Thu, 21 Sep, 2017 at 11:38 AM
UNIT NETWORK CONNECTION – DAISY CHAIN This article explains how to connect multiple GeoComp Lab Systems units. Same information can also be found in the...
Thu, 21 Sep, 2017 at 11:39 AM
If the computer cannot communicate to your testing station, first please do the following first;
Restart the computer.
Reboot all the machines in your ...
Thu, 21 Sep, 2017 at 11:39 AM
Changing Computer Sleep Mode to Never If you do not set your computer to "never" sleep mode, when the computer goes into sleep mode during an ...
Thu, 21 Sep, 2017 at 12:13 PM
If the computer cannot communicate to your testing station, first please do the following first;
Restart the computer
Reboot all the machines in you...
Thu, 21 Sep, 2017 at 11:39 AM
Network Test - Nettest There is a software called DIAGS that comes with each Geocomp Lab System. You can use Diags to run a network test. for troublesho...
Mon, 26 Mar, 2018 at 5:10 PM
Network Test (Nettest) for older systems If your system is Version 4 or older, the following instructions are for performing a Nettest for one unit at ...
Wed, 22 Nov, 2017 at 12:07 PM
If you replace the computer that is used to run tests, you will need to transfer the Geonet card (PCI or PCI-ex port) from your old computer to the new o...
Wed, 14 Aug, 2019 at 11:06 AM
The communication to the drive is with com cable through the COM port of the computer. The communication can get lost if the com port of your computer has ...
Wed, 14 Aug, 2019 at 11:38 AM