Calibration
Articles related to calibration of systems/sensors
Calibration of LoadTrac II and FlowTrac II sensors Basic Principles In order to calibrate the transducers used in the LoadTrac-II/FlowTrac-II system, ...
Fri, 22 Sep, 2017 at 4:53 PM
Calibration of ShearTrac II sensors Basic Principles In order to calibrate the transducers used in the ShearTrac II system, you will need an independe...
Fri, 22 Sep, 2017 at 4:55 PM
Calibration of LoadTrac III sensors Basic Principles In order to calibrate the transducers used in the LoadTrac-III system, you will need an independe...
Fri, 22 Sep, 2017 at 4:56 PM
Machine Compressibility For consolidation during a test, data are collected that relate to the total deformation which occurs throughout the system ...
Fri, 22 Sep, 2017 at 4:57 PM
Calibration of Resilient Modulus System Basic Principles In order to calibrate the transducers used in the resilient modulus system, you will need an ...
Fri, 22 Sep, 2017 at 4:58 PM
Calibration of Large Shear - ShearTrac III Basic Principles In order to calibrate the transducers used in the ShearTrac III, you will need an indep...
Fri, 22 Sep, 2017 at 4:59 PM
Zeroing Sensors Between tests, the load cell output will usually drift a small amount. At best, the no-load condition will be in the range of ±0.02...
Fri, 22 Sep, 2017 at 2:39 PM
Question: When I start a test, the program gives me an error message stating that the calibration factor is too small. I cannot run the test. I checked ...
Wed, 11 Oct, 2017 at 3:03 PM
Question: I used our calibrated gauge blocks to check our displacement sensor on the load frame. It appears to give readings roughly one half the actual ...
Wed, 11 Oct, 2017 at 3:15 PM
Question: Can I use a new calibration factor and apply it to the previous test I have already run and get the correct results? Answer: Yes, you can. Ope...
Wed, 11 Oct, 2017 at 3:15 PM